Titan V2 Basic Module Rear Wired | GATE

GATE Titan V2 Basic Module Rear Wired – for your replica

This trigger unit replaces the traditional trigger contacts and cut-off lever in your version 2 gearbox. The GATE Titan transforms your AEG into a programmable platform with advanced fire modes and battery protection. With the airsoft MOSFET system you gain direct control over trigger response, burst modes, and cycle detection. You configure the unit via the programmable card or USB link with the GATE Control Station application.

Technical specifications

The Titan V2 Basic Module features a black finish and comes with rear wiring for installation in the stock. The system includes an electronic trigger board, installation kit, and quickstart guide. The unit supports trigger sensitivity adjustment, three fire selector modes, cycle detection, 3-round burst, burst full auto mode, low battery warning, and battery protection. It also features AUG mode support, manual brake settings, diagnostic functions, and firmware update capabilities.

Compatibility and application

This trigger unit is designed for version 2 gearboxes in AEG replicas. The rear wired configuration makes it suitable for replicas where the wiring runs through the stock. Installation requires opening the gearbox and replacing the original trigger contacts. Experience with gearbox assembly is recommended for correct installation. The system works with standard AEG motors and gears, and offers programmable functions for both CQB and field builds.

Ready to add the GATE Titan V2 Basic Module Rear Wired to your setup?