Steel Trigger | WE AR Series | Ra-Tech

Steel Trigger | WE AR Series | Ra-Tech – this trigger for your replica

This trigger from Ra-Tech is a steel upgrade part for WE AR Series GBBR replicas. It replaces the standard trigger in your lower receiver and provides a more direct firing response with less play. If you notice that your current trigger has too much movement before the shot breaks, or if you are looking for a more consistent trigger pull for your GBBR trigger upgrade, then this part is a logical choice.

Technical specifications

The trigger is made from steel with a black finish. The design follows the original geometry of WE AR triggers, allowing it to fit into the trigger guard without modifications. The steel construction offers resistance to wear during frequent use. The contact surface with the hammer is precisely machined for a clean reset after each shot.

Compatibility and application

This trigger is specifically designed for WE AR Series gas blowback replicas. Installation requires disassembly of the lower receiver and removal of the trigger pin. Basic knowledge of GBBR internals is recommended for installation. The part works with both standard and upgraded hammer units within the WE AR platform.

Ready to add Steel Trigger | WE AR Series | Ra-Tech to your setup?